Robin Hoods Playground

Like your mother always said, "Patience is a virtue!" It turns out that all my problems were because I was doing it too fast. You must wait from when you turn the drive off before you press any key (at least with my drive). I successfully restored and flashed my 360! Thank you to everyone ...

Sorry if I put too much information at once. I'll try to do another restore and take my time. Thank you to everyone. I'll post back with results.

Just wanted to drop in and say hello. This is a great site with good information and tutorials. All the best to those involved with it.

Update: I just tried to restore back to the original firmware and it did the same thing. It erased fine, then it says make sure the Benq is off (which I did) and press any key (which I did). Then it says Press yes to resend... (as usual) Turn on drive... (as usual) Here is where it should say MTK Ve...

Trying to flash a Benq with iPrep following the video guide on here. It read okay, but then when it was going to write, before I could press yes to continue to send the signal, it started to try to write (with the Benq off), it started with bank 1. I turned on the Benq, but got nothing. So, I'm goin...