Robin Hoods Playground

i got my onboard nforce sata chipset to work with no problems.. i have a benq drive though.

there is a new xbins auto connect program out. the old one doesn't work anymore. Google for Auto-xbins 2008 and you'll find it, if cofree hasn't added it to the download section already. any yes, you can use ixtreme 1.4 for hitachi's with the 47. edit: just checked the downloads section and its in ...

first i want to thank all you guys who helped me out. i was able to flash my drive, and backups are working. Looks like nforce sata will work with phillips/benq, just make sure your plugged into the right port. Thx guys !

so now that i checked my dump.. once i boot into iprep am i going to have to start from scratch and re-read my drive? or will it go straight into firmtool ?

Ok stupid me. After looking at my motherboard i have two sets of sata ports.. one for the silicon image and one for the Nforce chipset. i was plugging into the silicon image set :x so i then plugged into the correct ports and i was able to get a dump with a Green Success! Woooo So i took the dump (C...

[Removed]

i want my via ! ! lol

just ordered VIA VT6421A from tekgems.. project is on hold until shipment comes in.. How long does shipping usually take? Im in texas

Ok so i follow instructions to the T but i am unable to get out of Status : 0x7F I made sure xbox was off... hit y at resend.. turn on xbox... 10 sec.. then off...10 sec than back on Status never changes from 0x7F... i was expecting it to switch to 0x51 and 0xD1 when i powered on xbox but status sti...

Ok one last question... :mrgreen: So if it reads all my banks (crossing fingers) and i get a Reading Finished... the dump will then be placed on my usb flash drive? What proggie am i going to use to check dump and verify that i have a good key? i already updated firmtool in iprep, but as far as soft...

Ok so im going to go ahead and boot into iprep, run dben and go through the whole off.. on then off for two seconds deal, and hopefully get 0x73 after it reads banks... but possibly i may get stuck at D1 due to my Nforce chip. Is this accurate? also how do i know when the reading of my bin is ( comp...

Ok so i chose "Switch To IDE Based Controllers" and now my Nforce Sata is showing up. What you guys think.. give it a shot? http://i103.photobucket.com/albums/m125/thisisalex02/nforce.jpg Copied from the tut: Philips/BenQ/LiteOn VAD6038 Tutorial You will need: • VIA or NForce SATA chipset ...

So before i flash the firmware on my benq drive i wanted to verify something before hand. While making bootable drive in iprep it is showing my silicon Image SoftRaid controller.. and not my Nforce Sata. Will this still work? I get both MTKflash and dosflashcompatible in green so i think its a go, b...