Robin Hoods Playground

I tried moving th jumpers around and can't get a HD recognized on the system. SO, I moved jumpers to the mat it came to enable ports c,D which are the 2 inside. Before all this I was using the one closest to the front like you had said. I can get a HD hooked up to any other SATA port on my board fin...

I just took the card out and enabled the other 2 ports. All 4 ports are active now. They call port A, thats in the back. I'm assuming this is port 1, the correct one to use? Trying it out now.

Funny you say that. I did the original flash ( a few eeks ago) with a Nvidia chipset. In Iprep it shows me having 3 Nvidia controllers. I really have 6 sata ports in all. I wasn't sure what one to use, I tries all 6 ports and still no luck with any. Since the flash went "bad" I said screw ...

OK, thats what I have been doing. The only thing that I did different this time was I renmed the file. Really it was already named benq-ofw except it was in CAPS. I tried the restore and same thing. After I type rben and serial, it says it will restore the original FW if it's not the FW the process ...

Yes, I read that guide before. I guess I am unfamiliar on what Toolbox is supposed to be doing and how to tell if it's good. I open the Original FW in toolbox, it puts the key in a box below. It then says to in type or paste key (but it's already there), I hit replace key and it says OK. Is that the...

First off I am working with a BenQ drive using iPrep. I tried to flash, seemed to go ok, it read all the banks but will not read an original or back up disc. So lucky for me I did stop and make a copy of my original FW. I have it, and it reads in Toolbox and matches what I also wrote down. So I deci...