Robin Hoods Playground

CoFree wrote:what was the problem man.

other than this.

Nax wrote:Jungleflasher does not detect my drive.

iPrep would always give me Geremia's DVDKey method failed or invalid DVDKey wherever I try to plug in the SATA port. Ack! I just flashed with 1.5, and now 1.51 is out...

I got everything working. I managed to dump the key using Jungleflasher. Got it to read the drive. Then I tried to erase, but it froze, so I used the dosflash/l-o-eras method and everything works fine now. THANKS everyone for helping me out.

That generally means that something isn't setup right. It could be anything from the chipset that you're using to any of the components in the line from the drive to JF. I would start from scratch. Memorize the tutorial and then do it. I have done everything correctly step by step. I don't know wha...

iamwatt wrote:i would say make sure you're doing the drive preparation stuff correct, the open tray, power off, push in half way but push in a little more than half way as CoFree does it and then power it back on. . .

I'm doing everything fine, but it still does not work.

what firmware are you using? and is the probe indicator light turning green. . . ? 1.5, and yes the indicator turns green. I've watched the video several times. I've flashed BenQ drives, but the LiteOn is the one giving me problems. Jungleflasher does not detect my drive. I'll try another computer....

iamwatt wrote:are you using the probe or did you solder the 707 points?

I'm using the probe, and CK3.

Hey, I just got the VIA card, and now I'm trying to dump the key.

I'm using iPrep 8.8 and I keep getting Geremia's Method failed or something like that. Any help? Thanks.

What SATA chipset are you using? I have the same problem with nForce. I just placed an order on a VIA chipset.

lilrevuk wrote:with nforce boards, try setting your sata mode to legacy (sata) in your BIOS.

I checked my BIOS and there doesn't seem to be a way to set it to Legacy.

with nforce boards, try setting your sata mode to legacy (sata) in your BIOS. Are you using Iprep?? Make sure you are using the primary port on any sata that you try. It might be worth looking at some of the other programs that can be used, a couple of them tell you if there is a drive connected on...

Hi, I don't know what I'm doing wrong, but when it says press y if you are ready, I press y is says DVD Key is invalid file not found: key.bin key not found dummy bin. What should I do? I followed the video instructions. I'm using an NVIDIA nForce 430/410 Serial ATA Controller, and a CK3Pro with pro...