Robin Hoods Playground

Can someone clarify for me please, is this LTU firmware ONLY for the replacment PCB's ??..i have a kamikaze dg4ds i am updating and have downloaded latest firmware packs from xbins but the new jungle flasher is only loading lt 3.0 as the firmware.

back ups working fine on this lite on i just flashed that has taken the latest dash update...just tried mw3

heh...nothing to worry about...got it flashed with the pmt method

wish i had checked out before i updated this box i have here to flash the drive on....im going to just go ahead and flash it anyway..its not being used onl9ine so should be fine...i hope

ok, but the benq drive is also a pal console...does it play on that because it is a jtagged console ? a jtagged console is efectively regionless ?

I have 2 modded boxes with LT1.9, one is a benq and one is a toshiba jtagged...i have pro evo 2011 which abgx states as being NTSC..plays fine in my jtag but in the benq it it say wrong region, i understood that the modded firmware lets you play games (backups) from any region..is this correct or is...

I had this dumping but was getting non identical dumps EVERYTIME, so i shortened the wires, from then it will not read so today i removed everything for the lpt cable and i made complete wires with spare resistor stems on the ends to get a good connection and isolated them, powers plugged into the 3...

i started out on this jtag about a year ago, i started putting pin headers on the jtag points and it go left there, i have been soldering the wires to the headers and in some points i push through a spare rod of resistor wire and soldered to that..it was reading fine, just not identical dumps, then ...

got nandcompare, loaded three dumps into it, clicked construct and it said it has made a good dump and saved it..im not satisfied though, i desoldered all the wires from the lpt jtag and board and replaced with wires from an old ethernet cable, it still wont let me dump...it makes no sense, i didnt ...

thanks again !. I thought it was imperative that i get 2 identical dumps from reading the nand, didnt know i could do that...i read somewhere that the wires being to long can cause this..so i cut them all down to under 30cm..now im getting the 'cant continue' bulls**t from nandpro...have i cut them ...

5 dumps now, none of them identical yet, is there an issue ?

I got NANDpro reading fine, i have done 2 dumps and used total commander to compare, it says 21 differences found, is this normal ?, i have started another dump, i assume i just compare this new one against the first 2 and if i get an identical reading i can use either one of them as my NAND dump ?

Thanks cofree..but for me, less is more and when i say less i mean less money ;) extremeflasher, thats very useful, i think i will jtag it, i did start to do it once but there were so many different guides and wasnt sure which is the latest easiest method, i already have pin headers soldered to the ...

soldering not a problem, i can desolder and resolder TSOP chips with ease as i have the correct tools but whats the benefit of a jtag other than the lobbies thing, i dont play online really much, what i would like is a set up like my wii, where i have a hdd with all the games on it without the need ...

I have not yet jtagged it, not really had the time..is it worth doing still with the new updates that flashes the drives back to stock firmware ? if i update the dashboard then the jtag is effectively gone ?..wheres the easiest guid to do the jtag if its still worth doing ? i have switch and resisto...