Video:: Guide for flashing the 360 BenQ with Iprep101 v006

[CoFree]

This a video guide for flashing the BenQ drive.
The programs you will use are Iprep101 v006 and Firmware toolbox v4.5.You can find them here
http://www.robinhoodsplayground.com/for ... f=112&t=48

There is one thing.I never powered down the drive so I only had to see the D1 flashing the first time.
When you do your modding you will see the D1 flash both times you are getting in the drive.
Once when you do the dben(dump) and then after you reboot in dos after you make a copy of you firmware.
When you do the fben(flash) you will see it again.
I have a copy of my original firmware so I did not need to stop in the middle of the dump/flash.


FULLSCREEN


You can download this video here
This video is 43 MB so give it a minute to download.

flashing the Benq 360 drive.avi

[CoFree]

Here is a different video guide I did after I put the blaster on the 360 BenQ I have.

FULLSCREEN

There is not much difference from the other benq video guide.

flashing the Benq 360 drive with a blaster.avi