The pinout is self explanatory head on down to radio shack and buy the bits....don't forget to raid moms sewing kit as these are just sewing needles used for the probes.....I just had to throw in a LED to let me know when its on
YOU STILL HAVE TO CUT THE TRACES FOR THIS TO WORK
THIS HAS BEEN TESTED WITH THE LED....NO GO WITH THE LED!!! (DO NOT INSTALL IT)
CUTS THAT YOU MAKE IF YOU USE THE Boxxdr Method Trace Cuts YOU MUST JUMP ONE WIRE ACROSS PAD 101
The extra pin is for the 7000 series liteon, I did not include it on my probe but after thinking about it I should have.
THOSE ARE 2 10 OHM RESISTORS WIRED IN Series
To dump your drive hold both pins in the holes so that DOSFLASH can see the drive then just tilt out your negative pin to read the bin files
