E79 after Jtag on Zephyr

Only things pertaining to J-Tag
Forum rules
Only post or question about doing J-tag on a 360.
All other post/question will be moved or trashed.
Post Reply
pasck11
Peasant
Peasant
Posts: 1
Joined: Fri Feb 12, 2010 7:52 pm

E79 after Jtag on Zephyr

Post by pasck11 »

Hi i just jtagged my console an it was working fine then i got rrod code 0020 and soon after goes to e79 code 1033. I would reboot it and it would be fine but it kept happening so i opened up the xbox to see if any wires were off. There were 3 off so i resoldered them and now it will never boot. I have tried everything i have read and i also put a 100 ohm resistor between the two points that are real close together.(i don't know their names) And still nothing. The only thing i can think of is that one of my wires may be too long.

P.S.

I thought it might have been my db1f1 point so i put it on the ft1u2 and still didn't work. Sorry if i got those names wrong.

Any suggestions will be much appreciated.
User avatar
technoe
Ally of Robinhood
Ally of Robinhood
Posts: 1767
Joined: Wed Jan 14, 2009 2:30 pm
Location: Clarksville, TN

Re: E79 after Jtag on Zephyr

Post by technoe »

It honestly sounds like you got something soldered in the wrong spot. What kind of board are you working on? Are your diodes facing the right direction? Make sure you haven't soldered through the board to the metal casing below.
Image
Today Money, Tomorrow the WORLD!!
Post Reply

Return to “J-Tag”