flash hitach rev59 with jungleflasher with benq fw

[daveycalhoon]

Hi all, need some wiht a problem and was wondering if anyone could help. my old benq drive broke the other day and i have a hitachi rev59 replacement. i have the latest version of JF 1.72 and my old benq firmware and key. i have always had benq drives in the past and so have never had to spoof a drive before, which is what i think is required for this drive swap. i have used the JF guide to attempt to get ixtreme 1.51 onto the the drive with my old benq key, but it keeps flashing back to stock!!! not sure why. if someone could help me with the steps required it would be much appreciated.

cheers dave

[daveycalhoon]

Right managed to do it. realised i was doing it right, the problem was when i checked that ix 1.51 was flashed on the drive by re dumping it it just comes back as stock on classsic mode even though it was on there.

process is

flash with ixtreme in hitachi tab
goto fw tool and load in benq fw and press spoof
then go back to hitachi tab and check auto spoof and hit Auto spoof!! easy

cheers