iprep failing to dump with BenQ

[zdubya23]

I get to the stage where iprep recognizes my drive and flashes 51/D1, but after I turn it off, wait a few seconds, then turn it back on it just flashes 52/D2 and it doesn't dump.... I've flashed other 360's with this same setup before and it worked fine, any ideas why it is doing this? Thanks.

[pluto_00]

are the other one's you did also benq's?

What setup you have ? DO you have the sata card vt 6421?

Benq's can be picky...

So give us some more info about what you are using to get it done.

[MsK]

yep.. what sata controller are you using??

& also >> It's definatly a BenQ.. not a Lite-On right??

[parminder]

if you havent pulled out wires or changed any settings then it shouldnt b a problem dumping the drive, look up n c if its a lite-on like msk said

[m60_maniac]

what iprep u using? u need 6.2, not version 7.0 onwards

[zdubya23]

blah, ya it's a lite-on.....so is there any known way to flash a lite-on yet?

[MsK]

blah, ya it's a lite-on.....so is there any known way to flash a lite-on yet?

you can't flash it yet but you can dump the key & transfer to a benq drive... prolly best to wait we think something is coming soon