Help with BenQ
Help with BenQ
Not sure were I am going wrong. Using Iprep to install all files to Sandisk 4.0gb flash drive. Benq ixtreme 1.1. I disconnect all IDE and SATA drives and HDD boot and my asrock 939dual-sata version 1.50 mobo says to install boot device. I tought that it was suppose to boot into dos iprep screen but nothing. Can someone lend me some advice?
Re: Help with BenQ
have a look over this.
http://www.robinhoodsplayground.com/for ... =110&t=277
if you have done this
then your computer is not booting on your flash.there maybe a setting you need to change in your bios
you can try making a boot drive on a floppy.most computers have a easier time booting on a floppy disc
http://www.robinhoodsplayground.com/for ... =110&t=277
if you have done this
then your computer is not booting on your flash.there maybe a setting you need to change in your bios
you can try making a boot drive on a floppy.most computers have a easier time booting on a floppy disc
Re: Help with BenQ
I tried it with floppy, after it read all the banks and gave me a DATSUM it says "Not ready writing drive A, Abort Retry Ignore"what next
Re: Help with BenQ
did it dump a good copy of your orig firmware.
open it with firmware toolbox v4.6
you may need to build your own hacked firmware
open it with firmware toolbox v4.6
you may need to build your own hacked firmware
Re: Help with BenQ
How do i build my own, can you point me to a thread maybe.
Re: Help with BenQ
have a look at this it should help.
http://www.robinhoodsplayground.com/for ... =110&t=438
http://www.robinhoodsplayground.com/for ... =110&t=438