Blaster v1 on a BenQ
well guy i put a 360 Blaster v1 on my BenQ drive.
It went perfect.
Did a dump and flash.Alls well.
Here are some pictures of the install.
There is one small point i would like to make.The place where you mount the small board on the back will no stick down.The added HDMI port makes this impossible.
Blaster v1 on a BenQ
Re: Blaster v1 on a BenQ
I like the blaster, but if you study what it is, you could easily make one using just a couple of sata extension cables and some minor cosmetic mods to the case. But thats why people like the blaster, there are no case mods to do to install it, plus the added benefit of having an on/off switch and molex power connecter makes life a little easier too.
Sadalius
No questions by PM please
No questions by PM please
- Jman 31
- Ally of Robinhood
- Posts: 916
- Joined: Wed Nov 07, 2007 2:51 pm
- Location: Somewhere in the south
Re: Blaster v1 on a BenQ
I think it also has a mode b switch for the hit drive doesn't it?
ROBINHOOD'S PLAYGROUND
Re: Blaster v1 on a BenQ
It sure does. Shame on me..... But, the mode b switch doesn't work on 78 or 79 hits. The original one had problems with certain versions of hits to, so you had to solder in the "FIX" PCB. The new ones don't need the "FIX" though.
Sadalius
No questions by PM please
No questions by PM please
Re: Blaster v1 on a BenQ
the v2 blasters make you power the drive with the 360
Re: Blaster v1 on a BenQ
I'm confused, will this work with the HDMI version?
[url=http://www.xboxlc.com/profile/rkd2398[/url]
Please No Questions by PM, Use the board that's what it's for.
Please No Questions by PM, Use the board that's what it's for.
Re: Blaster v1 on a BenQ
mine does
Re: Blaster v1 on a BenQ
The Blaster NE is a joke compared to the V1, there's no way to power the drive on and off again like you need to.
Today Money, Tomorrow the WORLD!!
Re: Blaster v1 on a BenQ
yea
i will not even use the ne blaster
but
love the v1
i will not even use the ne blaster
but
love the v1