Replacement of Benq Drive

[Doctor360]

Hello

Can some please help

I have a Benq drive and a Spare Benq Drive, the first drive is Failing badly and would like to replace it with the other Benq drive,

But i dont know how to do this as i know there have different keys also

I have both Org firmware form both drive on backup any advice and guide wouold be great many thanks

[HaGGardSmurf]

This is easy. Since they are both benQ's there is no spoofing...

What you do is:

1) Locate your failing drive's OFW.
2) Open Jungle Flasher
3) Decide if you want to flash iXtreme, or keep the drive stock
4) If you are flashing iXtreme, load the benQ iXtreme as target
4) If you are flashing stock, load the stock FW of the good benQ as target
5) Click spoof source to target (This will copy the key, into the fw)
6) Now flash your good benQ with the FW.



Also, before you flash, you can dump your failing benQ to make sure its key is the same, and that you have not confused the 2.

[Doctor360]

thanks HaGGardSmurf

For the quick guide then very helpful

Do i also use Jungle flashers to flash the good benq drive or an other problem

many thanks

[HaGGardSmurf]

thanks HaGGardSmurf

For the quick guide then very helpful

Do i also use Jungle flashers to flash the good benq drive or an other problem

many thanks

You can use Jungle flasher to flash the benQ, or you can build the FW (click spoof source to target) then save that firmware, and flash with iPrep. Its whichever you want.

[Doctor360]

thanks HaGGardSmurf

For the quick guide then very helpful

Do i also use Jungle flashers to flash the good benq drive or an other problem

many thanks

You can use Jungle flasher to flash the benQ, or you can build the FW (click spoof source to target) then save that firmware, and flash with iPrep. Its whichever you want.

Hello thanks for your help

When to try and load into Iprep 008.9 and i get this Error message invaid Fireware

the file im trying to load is the one i save from jungle flasher the Benq__CFW.bin

is that the correct file or should i have name it different

Many thanks

[dalecheesy]

No, you've already used jungle to make the firmware. Rename it to bencfw.bin then make the iprep usb stick bootable then make a folder inside of the backup folder and name it 1234567 (or the first 7 numbers of your serial) and then another one inside of that and name it 12345 (same again with the last 5 digits of your serial number) so it should look something like this backup/1234567/12345 and copy the bencfw.bin into the 12345 one (or whatever your serial number is) then boot into iprep and go straight to the fben 1234567 12345 (or your serial) command. Sounds more complicated than it really is.

Follow cofrees video from about the 5 and a half minute mark and you're good to go. viewtopic.php?f=195&t=5129" onclick="window.open(this.href);return false;