Error when MTK vendor is asked
Error when MTK vendor is asked
I got a dell dimension e510. i did iprep, but it didnt recognize a controller. i switch to the ide n put the the onboard controller n it works. got that goin. iprep launch ask for serial and stuff. load up to where they detect the 360 drive. it detects it but when wen they ask meto shut off and on it goes from 0x51 to 0xd1. when turn bak on it goes back to 0x51. can some help me????? idk if i really need to buy that via sata controller or not. cause it actually detects the 360 drive wen loadin iprep.
- HaGGardSmurf
- Ally of Robinhood
- Posts: 4088
- Joined: Tue Feb 03, 2009 9:46 am
- Location: Alberta, Canada
Re: Error when MTK vendor is asked
Try powering it off, pushing the tray half way in, then powering it back in. That should put it into vendor mode, and give you the correct status.
Re: Error when MTK vendor is asked
so when it ask to do the vendor press yes than power off than leave half open. than turn back on?