LITEON HELP SERIAL DATA IS BAD

[duckduck]

im tryin to flash a liteon drive and i did everything and when i stick it with the probe and run dvdkey32 it says serial data is bad
Im using the ck3 lite and the probe can someone please help me
If you need a video pm me your cell # and ill send it to you (try to see if im doin anything wrong

[rkd2398]

So you have the RS232 cable plugged into the CK Lite and the back of your pc? Are you getting a solid green light on the probe?

Give us some details about your process.

[duckduck]

yup yup, everythings plugged in i got the serial cable pluged into ports from a pci card ( a special one just for com ports) and the probe is green

[rkd2398]

Hmm, make sure that you are in the R707, because the R709 can give you a green light.

[duckduck]

of course its in the 707 i tried it like 50 times!!!

okay i connected everything i turn on the drive click eject, turn it off, put it in halfway and click turn on again
I shove the little anal probe into the 707 hole and it gives me greenness and when i click get key blahblahblah it was warning serial data is bad!

[sadalius]

This is a 7xxx series lite-on right? If it is, can you try with iprep? Make sure to try with irep v9 RHPG version if you do though.

[duckduck]

screw iprep jf is easier

[sadalius]

You might think screw iprep, but if iprep works in this situation where JF isn't.......

[duckduck]

but ive seen people flash with jf so i dont understand if it works plus iprep is so much more complicated

[HaGGardSmurf]

send the video to your e-mail address, then check your e-mail inbox, and download the video, then post it here.

Is your drive half open?