Need Help Plz , spoofing new benq as old liteon

[hockees]

Hi guys , i have a locked lite on 83850(my original console drive), so I decided to buy a new benq to replace it with the locked old lite on , i got the key and the dummy bin from the lite on , my question , now i wanna spoof the benq as a lite on so do i need to unlock the benq first ? i mean do i need to start flashing the benq from the beginning (from A-Z) just like i am flashing the drive for the first time ? or just skip the first steps and go all the way to write the dummy.bin that i got it from my old lite on ! sorry for this silly question but i havent done this be4 and this is my first time , well actually my second time , my first time i locked my lite on but it wasnt my fault , and if can someone help me with a good tutrial from A-Z to how to spoof benq as a liteon , any help it would be appreciated and thnx in advance.

[cyantific]

If you're using Jungle Flasher, hook up the BenQ drive. Click Intro/ATA and cycle the power on your CK3 (if you use that).

Next, dump the BenQ and save the OFW.

Then, load the dummy.bin from your lite-on backup as the Source and the BenQ 1.61 iXtreme firmware as the target.

Click spoof source to target and flash away.

[hockees]

So it means i dont need to click the (Benq unlock) in MTK flash 32 , right?

[cyantific]

So it means i dont need to click the (Benq unlock) in MTK flash 32 , right?

Whenever I have to do a BenQ all I need to do is hit Intro/ATA and cycle the power after 1 second. If that doesn't work you may have to do the BenQ Unlock.