I have used Iprep for long time and when I now start using Iprep 10.7 I wonder one thing.
Before I could choose if I wanted to dump or flash (example DSAM, FSAM). Now I only have SAM and then it starts to run dump. I have already got an correct dump of the firmware and now just want to flash the drive.
I write SAM 1234567 12345 (I have samofw.bin in the 12345 folder)
Then i get:
Directory already exists
Directory already exists
**** ERROR ****
BACKUPS\xxxxxxx\xxxxx\samofw.bin already exists
Process aborted.
How can I flash the drive when I already have dumped the key before? The drive is unindenfied so I cannot dump it again.
fben samsung? how?
-
commando_lee
- Ally of Robinhood
- Posts: 1821
- Joined: Sun Apr 26, 2009 12:50 pm
- Location: Up high in the tree looking out for the Sheriff of Nottingham
Re: fben samsung? how?
as long as you have already have the samofw.bin in the backups/1234567/12345
then you can just do this command at the first prompt
sam 1234567 12345 w
that will take you to the write command strait away
then you can just do this command at the first prompt
sam 1234567 12345 w
that will take you to the write command strait away
................................................................RobinHoods Very Own
.......................................
I do this for the fun and pleasure in helping people. But this is NOT my job. Post up on the boards with your question and some body will help you dont use the PM system.
.......................................
I do this for the fun and pleasure in helping people. But this is NOT my job. Post up on the boards with your question and some body will help you dont use the PM system.