Ok here we go guys this is what I cooked up after seeing what a German can do.....
The pinout is self explanatory head on down to radio shack and buy the bits....don't forget to raid moms sewing kit as these are just sewing needles used for the probes.....I just had to throw in a LED to let me know when its on
YOU STILL HAVE TO CUT THE TRACES FOR THIS TO WORK
THIS HAS BEEN TESTED WITH THE LED....NO GO WITH THE LED!!! (DO NOT INSTALL IT)
CUTS THAT YOU MAKE IF YOU USE THE Boxxdr Method Trace Cuts YOU MUST JUMP ONE WIRE ACROSS PAD 101
The extra pin is for the 7000 series liteon, I did not include it on my probe but after thinking about it I should have.
THOSE ARE 2 10 OHM RESISTORS WIRED IN Series
To dump your drive hold both pins in the holes so that DOSFLASH can see the drive then just tilt out your negative pin to read the bin files
Homemade Probe for the 8000 ver 2 and 9000 LiteOn
- Shootsteel
- Ally of Robinhood
- Posts: 546
- Joined: Tue Feb 03, 2009 1:28 pm
- Location: Florida...Somewhere in the Swamp.
Re: Homemade Probe for the 8000 ver 2 and 9000 LiteOn
Damn good man
thanks for the guide
thanks for the guide
- Shootsteel
- Ally of Robinhood
- Posts: 546
- Joined: Tue Feb 03, 2009 1:28 pm
- Location: Florida...Somewhere in the Swamp.
Re: Homemade Probe for the 8000 ver 2 and 9000 LiteOn
Thanks man I just added two pics one that is clickable.....
- commando_lee
- Ally of Robinhood
- Posts: 1821
- Joined: Sun Apr 26, 2009 12:50 pm
- Location: Up high in the tree looking out for the Sheriff of Nottingham
Re: Homemade Probe for the 8000 ver 2 and 9000 LiteOn
Some good work there SHOOT, well done
................................................................RobinHoods Very Own
.......................................
I do this for the fun and pleasure in helping people. But this is NOT my job. Post up on the boards with your question and some body will help you dont use the PM system.
.......................................
I do this for the fun and pleasure in helping people. But this is NOT my job. Post up on the boards with your question and some body will help you dont use the PM system.