hey guys got another xbox 360 that has another problem. I bought this one on ebay and i'm currently trying to fix it. When i got in the mail today I went to go check what the problem is. When I turned it on it worked for a second then it froze. Turned it on again then no ring of light or video.
So I opened it up, did a few adjustments, and heatgun the motherboard. When I turned it on it gave me error code 0102. I was like okayyy....... Tried to heat the gpu only and it still gave the same problem. So I decided to heatgun it again and now it gave me 0110. Any suggestions how to fix this? I'm afraid if I heatgun the mobo the 3rd time it might melt the solder in the gpu.
error code 0110
-
- Squire
- Posts: 22
- Joined: Sun Sep 20, 2009 5:47 pm
Re: error code 0110
not enough temp on heatgun,it has to be 325-350 degrees,your joints are probably "dry" reballing gpu is normally done by machine,very rarely works without the proper gear.There are several good films on utube showing how its done.
- HaGGardSmurf
- Ally of Robinhood
- Posts: 4088
- Joined: Tue Feb 03, 2009 9:46 am
- Location: Alberta, Canada
Re: error code 0110
That is the point in reflowing, you want the solder to melt. The rule of thumb to make sure your gun is hot enough is to take a piece of printer paper, and move your heatgun across the page, and when your able to burn a consistent line, its hot enough...specialbusboys wrote:I'm afraid if I heatgun the mobo the 3rd time it might melt the solder in the gpu.
-
- Squire
- Posts: 33
- Joined: Thu Aug 27, 2009 2:44 am
Re: error code 0110
alright i will get to work on it if i get the time. I been busy right now so I will keep you guys updated when i get the chance. any suggestions let me know.
- HaGGardSmurf
- Ally of Robinhood
- Posts: 4088
- Joined: Tue Feb 03, 2009 9:46 am
- Location: Alberta, Canada
Re: error code 0110
Make sure you dont hold the heat gun anywhere, you need to keep it moving, I usually move it in circles for about 10-12 seconds on each side (at 1000 degrees), then I kick my gun down to low (about 500 degrees) and do both sides again for 10-12 seconds.
-
- Squire
- Posts: 33
- Joined: Thu Aug 27, 2009 2:44 am
Re: error code 0110
well i heat gun the xbox again now it has 0020. any suggestions?