I'm replacing the original lite on 74 DVD drive as the laser died. It has Stock firmware.
I dumped the original key which I'm gonna flash into an identical replacement lite on drive.
I was reading the JF tutorial but I have a question. For dumping the key I had to use the half tray open. The next step is the erasing and then the writing.
The tutorial doesn't say if after extracting the key I need to close the tray or I should leave it half open and proceed to erase from that point and on. So i am hesitant to go on.
Any help greatly appreciated. Thanx
Lite On 74 ...Tray Hlaf Open or not?
-
- Bandit
- Posts: 116
- Joined: Sat Jan 10, 2009 10:01 pm
- Deathuntou
- Trusted Member
- Posts: 188
- Joined: Sat Feb 21, 2009 1:55 pm
Re: Lite On 74 ...Tray Hlaf Open or not?
Make sure you have the key first, I didn't think you could just extract the key on the 74 without probing, (Make sure the key is your key!!) leave the tray half open should be fine. Erase and write
-
- Bandit
- Posts: 116
- Joined: Sat Jan 10, 2009 10:01 pm
Re: Lite On 74 ...Tray Hlaf Open or not?
Yes I have the right key. I dumped it with the probe and the other cable that connects to the com on my PC (I can't remember the name)Deathuntou wrote:Make sure you have the key first, I didn't think you could just extract the key on the 74 without probing, (Make sure the key is your key!!) leave the tray half open should be fine. Erase and write
I looked at shootseele tutorial and I realized the tray says half way open.
Thanx for the reply.
- louisM92
- Ally of Robinhood
- Posts: 814
- Joined: Fri Jan 16, 2009 8:46 pm
- Location: The Port, not far away from the forrest :)
Re: Lite On 74 ...Tray Hlaf Open or not?
having your tray half open isnt required anymore
Need your drive flashed? PM me to sort something out
OR email me at louismoylan@live.co.uk
Flashing in the UK
Also do drive replacements