Page 2 of 2
Re: dump & erase Lite-On from via or mobo
Posted: Fri Jan 16, 2009 10:43 pm
by ronr179
hey cofree so you said your probably going to have a busy weekend so i wanted to flash my lite-on drive using iprep8.8 but im using the 360xtractor and spear . just wanted to know when using iprep to to do everything when should the spear be used to get the key?
THANKS
Re: dump & erase Lite-On from via or mobo
Posted: Fri Jan 16, 2009 11:03 pm
by CoFree
man
first.you are hi-jacking someones thread.
its not a big deal but it is thought of as rude.
next time just start your own thread.
you have made your iprep8.8 boot flash and have booted up on it.
it will tell you to open the tray power down push the tray in half way
and power back on.
at this point put your probe in the small hole that goes with the r707 point.
im not sure about that spear but the ck3 probe will light up so you know its in and ready.
then do the dump
leaving it in till after it has built your dummy file.
make sure to make a copy of your key for safe keeping.
Re: dump & erase Lite-On from via or mobo
Posted: Sat Jan 17, 2009 1:38 am
by ronr179
OK so sorry for posting in the wrong place didn't mean to hi-jack anyones thread. But thanks for the so quick response and help I'm going to give it a try.Will try and make sure it dosent happen again.
Thanks