Robin Hoods Playground

yah try it before you resend the command to your drive.... I would try it at a few different times, see if it makes a difference...

If you flashed it before, you should be able to access it again

i cannot find the enable 0800

and if i ever find it do i have to burn to a dl disc

I'm sure it's on xbins, but you can find it here as well.

i found it it was in xtreme 33

do i need to burn it to a dual layer disc

the drive will not eject

what the drive will not eject at all, or the drive will not eject now you have 0800 in it??

it wont eject at all

Right, go right back to the beginning...

Let me know your setup, OS and all the steps you took when you first did the dump/flash. You said your key was ok in FWToolbox?

Can you see the drive at all in iprep?

As long as you have a backup of the key from the drive, you'll be able to sort it with or without that drive. For some reason, it sounds like the drive is dead, but I know sadalius managed to bring one back that he thought was dead. The difference was though, he could get the drive to open.

never mind the lasti foundout what was was wrong there
now the drive is reconized but in iprep it say mtk vendor intro failed on port 0xdd00

yep, you need the drive to be half open/closed. the easiest way to do this is with a connectivity kit v2/3

Are you using a VIA card, or are you trying from your mobo?

i am using my mobo it read it the first time before i screwed it up do i need the 0800 disc or is this another problem

I think the only difference is that the firmguard is active now it has been flashed, even though the fw reports the drive as a 25...

You can try the 10 sec/bad flash method, the 0800 disc can have the same effect. I personally use Dosflash 32 for Sammy's though... If you want to try that, there's a few pointers here

any joy dude??