Re: please help
Posted: Fri Mar 13, 2009 1:09 pm
man
which one are you
if you are in the picture.
which one are you
if you are in the picture.
"Brute Squad" ... I like it
Robin Hoods Playground
Welcome to Robin Hoods Playground
http://www.robinhoodsplayground.com/forum/
please help
http://www.robinhoodsplayground.com/forum/viewtopic.php?t=4343
Page 2 of 2
Re: please help
Posted: Fri Mar 13, 2009 4:18 pm
Top row, 3rd from the right.
"Brute Squad" ... I like it
"Brute Squad" ... I like it
Re: please help
Posted: Fri Mar 13, 2009 4:37 pm
cool
I think given sometime
The site may have a sheriff in the playground.
I think given sometime
The site may have a sheriff in the playground.
Re: please help
Posted: Wed Mar 18, 2009 7:50 pm
In your post you said 1.5.. Make sure your using 1.51 and make sure you get the new ixdef files so it can read it. Happy modding 
~cucumber
~cucumber
Re: please help
Posted: Sun Mar 22, 2009 6:25 pm
hey i think i'll take your advice and upgrade to 1.5.1...but what do i do with my 1.5 to i have to reflash my ofw..then flash in the new 1.5.1cfw? i thought about doing this for a while now and i just didnt know how..and p.s if i ever need to ask a help question where do i do that?
Re: please help
Posted: Sun Mar 22, 2009 7:56 pm
Ok so just make your iPrep boot USB or use JungleFlasher, and just do a read DSAM, and then let Firmtool do its job, then run FSAM if you have a good key and backup the FW of course.
If using JungleFlasher, do a Intro/Device ID and do the 3 second trick, then when the drive shows a good status 0x73, then do "Read" and then open target 1.51 Firmware, and spoof to target, then save to file etc, and Flash in the Target Buffer Firmware "Flash"
If using JungleFlasher, do a Intro/Device ID and do the 3 second trick, then when the drive shows a good status 0x73, then do "Read" and then open target 1.51 Firmware, and spoof to target, then save to file etc, and Flash in the Target Buffer Firmware "Flash"