Page 2 of 2

Re: spoofing

Posted: Wed Apr 29, 2009 8:38 am
by CoFree
HAZ3 wrote:comments, advice, etc? please advise & thanks again as usual
well man you are jumping all over the place
im not sure what you are trying/wanting to do.
MG3 wrote:you have to use the 0800 disk to unlock the drive to re-flash it
there is no reason to use this

Re: spoofing

Posted: Wed Apr 29, 2009 10:08 am
by sadalius
Hitachi's doesn't use the 0800 disk. There was an 0800 created for samsungs and benq's, but not hitachi's. There is an unlock disk for the hitachi 79's, but it's an audio disk of a certain wav file. Not 0800.

Re: spoofing

Posted: Wed Apr 29, 2009 12:58 pm
by MG3
its a sammy spoofed as a hitachii with iXtrene 1.4 so yeah he does to be able to unlock the sammy drive... like you had told me before Sadalius, the spoof is only a very small bit of information that sends the drive key from another drive.

At this point his sammy drive has already been spoofed as a hit 47 and he needs to upgrade from 1.4 to 1.51, all he would need to do is unlock the sammy drive and reflash it, JF would get his correct drive key in the dump and keep the spoof. If he uses iPerp, it might be different and I do not have too much practice in it

Re: spoofing

Posted: Wed Apr 29, 2009 1:00 pm
by sadalius
Your right. With jungle and ix1.4 you would need to use the 0800 disk. Or at least the 10 second trick to unlock the drive. JF should then handle the rest all on it's own. I didn't read the whole thread, just part of it, sorry :oops:

Re: spoofing

Posted: Wed Apr 29, 2009 7:45 pm
by HAZ3
MG3 wrote:its a sammy spoofed as a hitachii with iXtrene 1.4 so yeah he does to be able to unlock the sammy drive... like you had told me before Sadalius, the spoof is only a very small bit of information that sends the drive key from another drive.

At this point his sammy drive has already been spoofed as a hit 47 and he needs to upgrade from 1.4 to 1.51, all he would need to do is unlock the sammy drive and reflash it, JF would get his correct drive key in the dump and keep the spoof. If he uses iPerp, it might be different and I do not have too much practice in it

he is correct this is essentially what I am trying to do.

originally i wanted to follow this method that haggardsmurf did: "Spoofing steps:

Dump the Firmware from the original drive (would have been your Hitachi drive)
Make sure you have a valid key in your Hitachi firmware (Its valid if its not all repeating letters/numbers)
Download iXtreme 1.51 for Samsung
Open Jungle Flasher
Load your original Hitachi firmware as "Source"
Open your iXtreme 1.51 for Samsung as Target
Click "Spoof Source To Target"
Click "Save to File"
Save it as "Samsung Spoofed as Hitachi" (Or something like that...)

Now what you have done is taken all the identification information from the hitachi firmware and put it in the samsung firmware. So your samsung runs the normal ixtreme firmware, but its identity appears to be the that of the Hitachi.

Now with that bin you just saved, you can use whatever program you would like, and flash that.

If you use iPrep, put it in the 1234567\12345\ folder.
If you use Jungle Flasher (If you dont close it after spoofing) you can just go to the MTK tab and flash. (If you have closed since spoofing the firmwares, then just open your hitachi FW as source, and your 'Samsung Spoofed as Hitachi' as target)
" Yea sorry for the late reply, you would have to rename it to use it in iPrep" this was per this thread viewtopic.php?f=63&t=4891&st=0&sk=t&sd=a" onclick="window.open(this.href);return false;

now do you think this would work as well? If so, i know for a fact I'd have do the following as well: viewtopic.php?f=63&t=4351" onclick="window.open(this.href);return false;

Now, if the latter is not needed then, I'll go the original route that mg3 suggested. please advise. thanks

Re: spoofing

Posted: Fri May 01, 2009 1:26 am
by HAZ3
bump :oops:

Re: spoofing

Posted: Fri May 01, 2009 3:56 am
by MG3
Sounds like you are trying to make it a little too difficult than it is. If I am not mistaken (and if I am please correct me) you will not need your hitachi firmware for this upgrade and you will not need to respoof it. The data is already there and will pretty much stay there as you are upgrading.

Steps on what I recommend you do:
Burn the activate.iso (0800) and put it in your Xbox 360 drive while it is connected to the PC
Open JungleFlasher and go to MTKFlash and click on Intro /Decive ID
Drive should be in vendor mode at this time
Now Read Firmware and save as OFW
Load the OFW and the 1.51 firmware in Firmware Tool
Click Spoof Source to Target f not done automatically and verify all the drive keys and data are unique and identical
You should notice that it will also poin out that the Sammy drive is still Spoofed as a Hitachi
Save the new CFW
Go to MTK Flash and Click on Write on the bottom right.


I hope that helps, I took this straight from the JunglFlasher v1.51 PDF that was posted in the tutorials section.
Good Luck