Best Way To Flash Back To Original Firmware
Posted: Wed Dec 16, 2009 5:44 pm
I'm about to flash my BenQ drive back to original FW. What is the best way to do this? Is JungleFlasher an option?--it seems easy to do as it works in Windows. I tried running JungleFlasher, but it would not recognize the BenQ drive. I'm using the VIA SATA card (the main recommended one)...and when I open JF it hangs for a bit, then after a couple minutes opens and shows 2 CD ROM devices (my main computer one and the BenQ), but when I click on the MTK tab, it doesn't show any device installed.
Should I flash this with iPrep instead using DOS? I can't seem to use my DOS boot CD since my C partition is greater than 32GB, so I may need to get a flash drive to do it that way.
In short, what is the best way to flash back to my OFW?
Thanks!
Should I flash this with iPrep instead using DOS? I can't seem to use my DOS boot CD since my C partition is greater than 32GB, so I may need to get a flash drive to do it that way.
In short, what is the best way to flash back to my OFW?
Thanks!