Robin Hoods Playground

I have two 8385 Liton drives i have my OFW for one and not the other. I am trying to re flash my 360 back to stock before i take the new update but JF finds my Liteon but when i press Lo83 info it says after i move the tray to full out position it says LO83 info extraction failed! I have never had this prob am i re flashing wrong? And am i stuck without my original FW backup from my other drive?

Any help would be appreciated
Thank you in advance

If the drive is already flashed then all you need to do is click where it says "dummy from ixtreme". You don't need to go through the same process to dump it again. This goes for all liteon drives.

Well i have just tried that and now it say'n "ixtream dvdkey extraction failed power drive with tray half open." and i do this over and over again I'm not sure what to do any more! my via raid driver is disabled as needed by JF and portio32 is installed with JF im not sure what I'm doing wrong anymore any other advice

Have you flashed the drives with ixtreme LT by any chance?

louis09 wrote:Have you flashed the drives with ixtreme LT by any chance?

Yes i have first version of LT and i wanna update to new version

Thats why you cant dump the drives then, once a drive is flashed with LT 1.0 it doesnt let you dump the drive for some reason, just open the dummy.bin for the drive as source and LT 1.1 as the target, spoof source to target, flash like normal, do the same for both drives

louis09 wrote:Thats why you cant dump the drives then, once a drive is flashed with LT 1.0 it doesnt let you dump the drive for some reason, just open the dummy.bin for the drive as source and LT 1.1 as the target, spoof source to target, flash like normal, do the same for both drives

Ok I do not have my original fw for eather of my 360 So am i screwed

Im not quite sure bud, there may be a fix for this some time soon