I searched multiple sites on how to fix this issue now i tried using Iprep 6.2 - 10.7 dos-flash. My issue is i cant get my flash drive to boot. My computer tells me (The drive is not ready remove the disk press any key to restart).
I am running Windows 7 32_bit
Also I don't have a clue what port my drive is on. I can't see it.
do I need the VIA card for this?
Bad flash Lite_on
- HaGGardSmurf
- Ally of Robinhood
- Posts: 4088
- Joined: Tue Feb 03, 2009 9:46 am
- Location: Alberta, Canada
Re: Bad flash Lite_on
You'll only need the via card if you cant see your drive, you havent gotten that far yet.
Does your mobo support booting from usb?
Does your mobo support booting from usb?
-
- Peasant
- Posts: 3
- Joined: Mon Apr 19, 2010 12:57 pm
Re: Bad flash Lite_on
So even if I have sata on my mother board I still need the card?
and yes it supports booting USB
and I am running CK3 as well
and yes it supports booting USB
and I am running CK3 as well
-
- Peasant
- Posts: 3
- Joined: Mon Apr 19, 2010 12:57 pm
Re: Bad flash Lite_on
I would like to say thanks for the reply but I got it just not with iprep.
What I did was:
1. Jungleflasher 1.72 / still could not find the drive would not eject or respond to anything.
2. Intro/device powered off/on within 1 second got vender mode reflashed to the place it was before it locked and the drive started ejecting.
3. reflashed to 1.61 and everything is good, plays everything is was made to and back ups.
What I did was:
1. Jungleflasher 1.72 / still could not find the drive would not eject or respond to anything.
2. Intro/device powered off/on within 1 second got vender mode reflashed to the place it was before it locked and the drive started ejecting.
3. reflashed to 1.61 and everything is good, plays everything is was made to and back ups.