Help with Jungle Flashing Benq Please..

[satan27]

im praying someone can help me.. for probably the past two weeks now ive been trying to flash my benq vad6038 (64930c) stock drive and having no luck at all here is a summery of whats been happening well i go to jungle flasher click on the mtk flash tab and pull up my benq drive properties under i/o ports and when i hit benq i get and error and when i hit intro i get failed.. im fallowing the tut perfect i believe and i running it all on xp with a VIA VT6421 raid chip set... but ya heres my log
to further show you whats going on
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
JungleFlasher 0.1.73 Beta (108)
Session Started Fri Apr 23 18:30:26 2010

This is a 32 bit process running on 2 x 32 bit CPUs
portio32.sys Driver Installed
portio32.sys Driver Started, thanks Schtrom !
Found 4 I/O Ports.
Found 0 Com Ports.
Found 9 windows drives C: D: E: F: G: H: I: J: K:
Found 2 CD/DVD drives E: F:


Sending Magic Keys to Drive on port 0xDE00
.. incomplete packet write
Sending Vendor Intro to port 0xDE00
Status 0x51
Re-sending Vendor Intro:
...................................
Device Intro failed!



does anyone have any idea's to fix this i would be most thankful =)

[shaky]

might be a stupid question mate but do you have the drive tray half open
also have you instaled ck3 drivers etc and does jflasher pick up your drive when it is conected to ck3

[satan27]

im not using a ck3 and i was told with a benq i wouldnt need too.. but ya drive has never been flashed so i was told from a few people that i dont need to do the half open tray trick.. i have tried it with no success though.. im just soo lost on what to do at this point

[shaky]

so how are you trying top flash it then what are you useing

[HaGGardSmurf]

Do the half open trick, thats the first thing I figured may be the problem here, but I tossed that aside since you said you are following a tut exactly. Try that, it should work, I had a couple problems with benq's a while back but the half open thing fixed it.

[who_be_dat]

I flashed a benq with LT 1.1 today took me 30 sec, just use the benq unlock on the mtk tab. Only works for stock benq, if the drive isn't stock use tray half open trick.

[brired]

for a stock benq you do not hit intro unless you are doing the vcc trick.you only (usually) hit benq unlock not both. :roll:the only other alternative is the drive is faulty,have you seen it working?