E79 after Jtag on Zephyr
Posted: Sat May 15, 2010 8:43 pm
Hi i just jtagged my console an it was working fine then i got rrod code 0020 and soon after goes to e79 code 1033. I would reboot it and it would be fine but it kept happening so i opened up the xbox to see if any wires were off. There were 3 off so i resoldered them and now it will never boot. I have tried everything i have read and i also put a 100 ohm resistor between the two points that are real close together.(i don't know their names) And still nothing. The only thing i can think of is that one of my wires may be too long.
P.S.
I thought it might have been my db1f1 point so i put it on the ft1u2 and still didn't work. Sorry if i got those names wrong.
Any suggestions will be much appreciated.
P.S.
I thought it might have been my db1f1 point so i put it on the ft1u2 and still didn't work. Sorry if i got those names wrong.
Any suggestions will be much appreciated.