Robin Hoods Playground

after flashing a few 934 drives i have found it very difficult to follow the instructions well almost impossible eg after you have dumped your key it is very difficult to hold the probe v2 in position while clicking the mouse and switching off and on the ck3 , so therefore now after i have dumped my key , without ereasing the drive i click on 0utro / ATA reset then repair my trace wires and then hook it back up open my source firmware in firmwaretool 32 the open target and flash as normal then i have two free hands one to click the mouse and one to turn off / on ck3
does that make sence

Yea that makes sense, and thats a smarter thing to do, rather than hold the probe the whole time.

thanks bud , any reports on the new xbox yet if the drive is flashable or not i hear there is a new drive in it

No news yet, as far as I know its just a 9 series v2 basically.