lite on drive question regarding Xecuter LT Clip and LT Swit
lite on drive question regarding Xecuter LT Clip and LT Swit
Hi I was going to get a new xbox as my old one with a benq died and was looking into the flashing of the lite on drive.I was first looking into getting the prode,but then I found the Xecuter LT Clip and LT Switch v2 *NO SOLDER*.but I have read that you need to take the lazer ribbon off to stop the tray open problem when you flash the drive.If this is the case would I be better getting the probe. still reading up on what to do to get my head around it,but I wanted to order one of the two so it gets hear next week as I've been without an xbox for 2 weeks!Thanks_ J
- tonyuk73
- Herald of RHPG
- Posts: 567
- Joined: Sun Apr 12, 2009 8:59 pm
- Location: 'its grim up north' U.K
- Contact:
Re: lite on drive question regarding Xecuter LT Clip and LT Swit
go for the probe, plus you can use it again. i use jungle flasher and ck3 conectivity kit and a v2 probe works a treat every time,no doubt one of the moderators will back me up with this one.And good luck.
no xbox for two weeks i bet you are pulling your hair out now
a good tut is here thanks to sadalius and cofree.
http://robinhoodsplayground.com/forum/v ... 195&t=3357
no xbox for two weeks i bet you are pulling your hair out now
a good tut is here thanks to sadalius and cofree.
http://robinhoodsplayground.com/forum/v ... 195&t=3357