Robin Hoods Playground

Been using a heat gun with liquid flux to repair RROD lately, fix rate seems the same as xclamp fix. Would it be a better fix to install x-clamp replacement after reflowing with heat gun?

what i normally do is a reflow then a xclamp repair, worked everytime so far

i use a heat gun too followed by xclamp mod but i only do the GPU, CPU and the ANA (HANA) chips with the heat gun, was wondering should i start doing the full board?

99% of RROD is GPU, no need to overheat the CPU.

Sometimes you'll need to do the ana chip but thats only if you have an ana error.

HaGGardSmurf wrote:99% of RROD is GPU, no need to overheat the CPU.

Sometimes you'll need to do the ana chip but thats only if you have an ana error.

thanks man in fact ive got a E74 to do this weekend so take it thats a dry joint around the ana?

Yep, as far as I know thats the issue.

The ana deals with all audio and video, so if your having audio/video issues it'll be GPU, if that doesnt fix it, it's the ana.

E74 is the ana 99% of the time.

Also, your not going to ever want to do the full board, there are lots of heat sensitive components on the board that will not do well under heat. Especially the capacitors.

It's best to use tin foil or foil tape and cover the parts of the board your not reflowing, but remember the foil will get hot so dont rest it up against a capacitor, as the heat will transfer into it.

thanks HaGGardSmurf

guys today i done the heat gun relow, focusing mainly the gpu but also the cpu, i got rid of the xclamps but when i boot still 3 red lights any ideas? id it dead?

is it a error 102
what error did it have

you should have started your own thread

CoFree wrote:is it a error 102
what error did it have

you should have started your own thread

sorry dude

no error nothing on screen n now when i start the box it makes a short noise, the fans shut down n the 3 green lights come on

t_chris wrote: the 3 green lights come on

do you mean the 3 red lights come on

get the error read over this
http://www.robinhoodsplayground.com/for ... 101&t=2962" onclick="window.open(this.href);return false;


--==SECONDARY ERROR CODES==-
The specific type of hardware failure can be determined by a "hidden" error code

* Turn the xbox 360 on, and wait till the 3 red lights are flashing.
* Press and hold the sync up button (the small white one), while holding that button press the eject button.
* The LEDs will now blink the first number in the code (as described below).
* Release the eject button and press it again.
* The LEDs will now blink the second number of the code.
* Release the eject button and press it again.
* The LEDs will now blink the third number of the code.
* Release the eject button and press it again.
* The LEDs will now blink the forth number of the code.
* Release the eject button and press it again.
* The LEDs will go back to the 3 red flashing lights.