Dosflash and new Samsung LT FW?

[xtnod]

Hello all, I've had my xbox on 1.61 for a while been out of the country for a year and just got back. Main question would regard my Samsung drive TS-H943 and the new Samsung LT FW.

I've always used iprep to make that bootable USB drive. Than use firmtool to make my hack firmware and flash it over with Dosflash.

Now my main queston is can I use firmtool to make a hack copy from my original key with the new Samsung LT 1.0 FW and Dosflash it over?

Thanks guys!

[HaGGardSmurf]

All you need to do is build your hacked FW from your OFW + your CFW, then you can use dos flash.

If you dont have your OFW for that drive then you'll need to go through al the steps do dump it first, then hack it, then go into dosflash. Make sure you have your OFW before your flash LT.

I'm about 95% sure dosflash will work fine, but I stick on the GUI side of things so im not completely sure. You may want to wait for cofree or someone else who does use the command line side to respond.

[xtnod]

Thanks HaGGardSmurf.

Yes I still have my ORIG.bin software/key handy kept it in a safe USB drive.

[HaGGardSmurf]

Thanks HaGGardSmurf.

Yes I still have my ORIG.bin software/key handy kept it in a safe USB drive.

Then you dont need go to through all the dumping step's, just load up jungle flasher, load ofw as orig, LT 1.0 as target, hit spoof, then save that FW as SAM CFW, and you can proceed to dosflash.

[xtnod]

Sweet thanks HaGGardSmurf!

Followed your steps and it worked flawlessly! Thanks so much again!

[HaGGardSmurf]

No problem, glad you got it!