Robin Hoods Playground

So i used iprep 10.7 to reload 1.51 on my 74950c LT drive.
i have the CFW.bin file it created in the BACKUPS folder.

now when i put that file into jungle flasher it says that the file is missing drive specific information.
i hit yes to proceed.

then it says do you want to repair the serial from the drive barcodes....

shoul di do that or no?

if i hit no it loads up the new LT+ firmware.

but how do i get it to load into IPREP12... always says a valid firmware source was not selected. only non-patched firmwares can be loaded.

i get this if i try to put the new firmware i got from xbins or the new one i just made.

You should just be able to take your original dummy file load that into JF as source load the LT+ as target spoof as save that file open iprep on the usb backups folder place the JF FW in there iprep 12 rename the JF made file to L74CFW and the use iprep to write whatever your backups folder numbers are 1234567 12345 W should write the FW to the drive make sure you remove the other one from iprep first and keys match in JF

i got the LT+ to load. but assassins creed brother hood wont load.

original games load.

ill have to wait and see if a diff copy works

iprep is not going to support the new LT+ firmware
its a world of jungle flasher now