iprep failing to dump with BenQ
iprep failing to dump with BenQ
I get to the stage where iprep recognizes my drive and flashes 51/D1, but after I turn it off, wait a few seconds, then turn it back on it just flashes 52/D2 and it doesn't dump.... I've flashed other 360's with this same setup before and it worked fine, any ideas why it is doing this? Thanks.
Re: iprep failing to dump with BenQ
are the other one's you did also benq's?
What setup you have ? DO you have the sata card vt 6421?
Benq's can be picky...
So give us some more info about what you are using to get it done.
What setup you have ? DO you have the sata card vt 6421?
Benq's can be picky...
So give us some more info about what you are using to get it done.
Re: iprep failing to dump with BenQ
yep.. what sata controller are you using??
& also >> It's definatly a BenQ.. not a Lite-On right??
& also >> It's definatly a BenQ.. not a Lite-On right??
Re: iprep failing to dump with BenQ
if you havent pulled out wires or changed any settings then it shouldnt b a problem dumping the drive, look up n c if its a lite-on like msk said
- m60_maniac
- Trusted Member
- Posts: 86
- Joined: Thu Jun 05, 2008 12:42 pm
- Location: wellkingborough, UK
- Contact:
Re: iprep failing to dump with BenQ
blah, ya it's a lite-on.....so is there any known way to flash a lite-on yet?
Re: iprep failing to dump with BenQ
you can't flash it yet but you can dump the key & transfer to a benq drive... prolly best to wait we think something is coming soonzdubya23 wrote:blah, ya it's a lite-on.....so is there any known way to flash a lite-on yet?