Robin Hoods Playground

I get to the stage where iprep recognizes my drive and flashes 51/D1, but after I turn it off, wait a few seconds, then turn it back on it just flashes 52/D2 and it doesn't dump.... I've flashed other 360's with this same setup before and it worked fine, any ideas why it is doing this? Thanks.

are the other one's you did also benq's?

What setup you have ? DO you have the sata card vt 6421?

Benq's can be picky...

So give us some more info about what you are using to get it done.

yep.. what sata controller are you using??

& also >> It's definatly a BenQ.. not a Lite-On right??

if you havent pulled out wires or changed any settings then it shouldnt b a problem dumping the drive, look up n c if its a lite-on like msk said

what iprep u using? u need 6.2, not version 7.0 onwards

blah, ya it's a lite-on.....so is there any known way to flash a lite-on yet?

zdubya23 wrote:blah, ya it's a lite-on.....so is there any known way to flash a lite-on yet?

you can't flash it yet but you can dump the key & transfer to a benq drive... prolly best to wait we think something is coming soon