Robin Hoods Playground

hey guys just wanted to know that if the 25 and the 28 are the same drive but different f/w. if so is it possible to just swap

the pcb board without spoofing it? i also search for trying to spoof ms25 to ms28 but nothing. i know how to spoof the the

key ms28 to 25 and patch the hack f/w with the orig key, is there anything else after that (this is where i'm stuck) or

everything is ok and ready to flash? thanks

im not real sure on the pcb swap.
it wont hurt to try.

firmware toolbox will spoof the v25 to report as a v28
that would be if your console had a v28 to start with

spoof a v28 into a v25 console
that would be if your console had a v25 to start with.

You can go from an ms-25 to an ms-28 without spoofinf, but you'll have to put your key in it regardless. You can't however go from an ms-28 to an ms-25 without spoofing.

hey it works perfect. My problem was that my laser was crapping out so i decide to get a new drive which was the ms25.

so my ms28 was already flashed. so i just switched the ms28 pcb board into the ms25 and it worked. Cuz i figured the key was in the pcb board and it was already flashed and so i tried and it worked w/o going through dumping keys and modding f/w saved me a lot time...lol well thanks again!

I didn't think you'd have any problems with it. Glad you got it going.