Lite On Soldering Question

[darrenp76]

Hi,

Im attempting to do my first Lite-On drive and I just want to clarify something. In order to flash the drive with the new Iprep 08.6, I need to Solder the points together on r707 and r708. I was going to just jump them with a wire soldered to each spot. Like this:

R707 X----wire----X
R708 x----wire----x

Sorry for the shady diagram but hopefully you see what I mean. Also, I read that I can leave them jumped after I read and flash the drive, is that correct?

[CoFree]

all you have to solder is the 707tx point the flash is going to go in the sata cable.

[darrenp76]

Ok, so jump a wire across the R707 points, not the R708.

Can I leave this wire on after the drive is flashed?

[CoFree]

you dont need to mess with te\he 708 rx point.
leave it alone.

as far as leaving the wire on.
im not sure
i leave mine on
but
i just got my probe in so i wont be soldering anymore.