Robin Hoods Playground

Hi ya like a noob i ripped the 707 lands off my lieon drive, will the ck3 probe still work or am i screwed?

what exactly do you mean??

If you mean you've ripped the pads off that you were trying to bridge, then you may be able to get the key with a spear from the hole above R07, but I'm not %100 sure. That depends on how much damage you've done to surrounding parts...

lilrevuk
is right the probe hole should work fine.
as long as you did not do to much damage to the board.

is just the 2 lands only i have ordered the probe so ill keep my fingers crossed

Thanks for the replys

Hi ya

Could I not just solder a wire from the 2 points on the diagram I have uploaded, or even solder a wire on to the big pad and stick it in the via hole and remove after???

if you could have a quick look please

Thanks

yea
that would work.
just dont mess it up man.
it would seem at your skill level if you mess that up its game over someone will need to help you fix it.

Personally, I think if you've got the probe on the way bide your time on that arriving...

I got lucky with my first lite on, had to send it off to somone who knew what they were doing

Remember if the drive dies before you get the key, you've got a goalpost....

yep
that is a very good point he made there.

Hi ya

Can I first say a big thanks to everyone and also big thanks to cofree, in the end i made a little solderless gadget out of a piece of knar wire.

All i did was to cut a piece knar wire make a small loop 1-2mm in the end and tinned it so it had a flat solder circle and a 3mm stripped length at the other.

Then i taped the blob to the tx pad and put the stripped length in the via hole.

Then i used jungle flasher to get the key, got my son to put his finger on the blob got the key 3 times to be sure, and compared them.

Then did the business!!! Wopppiiiiiiiiieeeeeeeeee

Thanks again everyone involved!!!

oh no am I trouble now?? That pic is just a bit to clear me thinks ooops, thats what I get for trying to be nice!!!

haha
i got it man.
just should have used paint to make it smaller
good job man

resized the pic hope this is ok now

Thanks again

made this pic aswell maybe help someone i think it is alot easier for less experienced people

yea good picture.
as long as your solder point is good and it makes good contact with the 707 hole you should be good to go.

Hi cofree is it possible to remove this post and maybe I can redo the post as like a tutorial that maybe you could sticky for me?

Thanks