Robin Hoods Playground

ok if i have a lite on drive and a ck3 pro what exactly do i need to solder on the drive to get key. can some one post a picture.

i moved your post to the right spot man.

you would take the back of the dvd drive off and then solder the r707 point

you dont have to solder the 708 now.

ok and then with that i can do the iprep tut right.

Yep, if you have them bridged correctly, you can run iprep and get the key

well it really dont look so hard cause all you have to do is solder the r707 together right and then that sould be fine.

thats right just the r707
but
its small
and dont get any solder on anything else.

well i just have to give it a try thanks cofree and everybody else that has made this possible.

i had a look at soldering that point...man its so small...ive read somewher that a small 2mm jewellers screw driver can be used to bridge the two points..so you basically hold the scredriver across the two points when dumping the keys....i havnt tried that yet, im just waiting for ck3 pro and probe to come....

ok i got just one more question on this subject if i use the probe to get key can i still use i prep tut if i get the key with jungle flasher?

well if you us iprep the use the iprep guide or you are going to try jungle flasher then of course use the jungle guide.

no what im asking is that if i use i prep can i still use the probe. sorry for not explaning right

yes
just after you open the dvd drive and close it half
put the probe in the hole and leave it in till you are done getting all the files.

man
I think your sig rocks
good job

thx cofree it took some time but i like it.

thank you cofree i will try to get the xtractor and the spear probe just incase

The first one i did,i packed blu-tac around all the points bar 707 and dropped a blob of solder on it,my eyes aren`t what they used to be.lol