Robin Hoods Playground

Hi ya

Can someone confirm that I can change my ms28 with a flashed ms25. I understand that all drives are 28 when flashed is this right????


Thanks

the v25 will work in your console that had a v28
but
the v25 would need your orig key (from your v28) in its firmware.

The v25 would need to be either spoofed to report as an MS-28, or you could just flash it with the firmware from your ms-28, that would work too.

i forgot 2 needed words in my post
"must spoof"
sorry

Hi guy's

Thanks for the replys

Im going to use jungle flasher, I have may orig and hacked bins for my 28. Using firmtool 32 am I right I have to use the spoof to target button anyway and then jobs a gooden??

Thanks again

I'm pretty sure the firmware you have will work straight off... You already have a hacked ms28 firmware with the key you're after, so there's no need to make one (I think that's right?)

The hacked bin is old firmware not the the new ix so dont want to use that. I was just going to use the orig.bin and then the new ix.15. Oh well im sure it will be fine.

Thanks

sorry, thought you was at 1.5

yeah either Jungle Flasher or Firmtool through a DOS Prompt will be fine