Robin Hoods Playground

First time using JF to flash a drive in Windows.

Anyways, just wanted to see if this was normal.

I followed the benq-sammy tutorial and when I flashed the drive it erased and flashed each bank individually. Ex:

Erasing Bank 1: ............
Writing Bank 1: ............
Erasing Bank 2: ............
etc


And lastly, when it verified the flash blanks, Bank 2 was : ........x...

Any indication as to what the x represents? I don't have the right power supply to test the drive but I did a final read and the flashed firmware looked good to me.

hmmm
not sure man

hell i just got a computer to work with jungle.
i did my first dump and flash of a lite-on with jungle.
now
that i got that worked out
ill try to mess with the samsung and t6he benq tomorrow.

i know iprep does not do the flashing 1 at the time
it does them all the writes them all.

i think its odd to say the least

The x's aren't anything to worry about if it said verify ok. I've seen that before, and asked about it on the jungleflasher IRC channel. They didn't explain what it meant, but was told that it was ok if it verified ok.