Robin Hoods Playground

Im tryin to flash a Hit 78 with JF 1.51 and i keep getting dump failed when i try to dump the key. I used the new JF yesterday to do to Hit 78's and it worked fine no probs, smooth as butter. Today i went to try it and it just keeps tellin me dump failed. I know the drive is good, i dumped the key and flashed it with 1.4 using FW toolbox and it worked out fine. So i tried it again with the JF and did it just like the pdf. said and also exactly like Cofree's tut vid and still nada. It will go into mode b fine, it shows the drive is there and what it is but thats it. If someone could help me or give me some insight, i would greatly appreciate it. As always, thanks for any and all help!!

no one huh? well i guess ill try this again and see what happens!!

man ive not done a v78 yet with jungle wait for one of the other guys

The only thing I can think of is to verify that all of your cables are good and connected correctly. Seeing how you've done two other HIT models before I don't see any reason to doubt your process.

I have a spare 78 at home. If I get time tonight I'll try it out, but I don't know how far I'll be able to get since I've been having trouble with the new jungleflasher. I did read one out yesterday, but I didn't flash that drive, it was a drive swap, so I just needed the original FW to get the key and spoof the new FW.

I have the same problem with JF (for the hits anyway)

If I were you, stick to what you know works. Just build you firmware in JF, then restore/flash with FWtoolbox 4.8

well i tried it again today with no results so i guess im gonna have to build it then flash with toolbox. thanks for the anwsers guys!!