Help with BenQ

[phelixnyc]

Not sure were I am going wrong. Using Iprep to install all files to Sandisk 4.0gb flash drive. Benq ixtreme 1.1. I disconnect all IDE and SATA drives and HDD boot and my asrock 939dual-sata version 1.50 mobo says to install boot device. I tought that it was suppose to boot into dos iprep screen but nothing. Can someone lend me some advice?

[CoFree]

have a look over this.
http://www.robinhoodsplayground.com/for ... =110&t=277
if you have done this
then your computer is not booting on your flash.there maybe a setting you need to change in your bios
you can try making a boot drive on a floppy.most computers have a easier time booting on a floppy disc

[phelixnyc]

I tried it with floppy, after it read all the banks and gave me a DATSUM it says "Not ready writing drive A, Abort Retry Ignore"what next

[CoFree]

did it dump a good copy of your orig firmware.
open it with firmware toolbox v4.6
you may need to build your own hacked firmware

[phelixnyc]

Ok I'll try

[phelixnyc]

How do i build my own, can you point me to a thread maybe.

[CoFree]

have a look at this it should help.
http://www.robinhoodsplayground.com/for ... =110&t=438

[phelixnyc]

Worked, thanx.