Robin Hoods Playground

hey guys i need help flashing my samsung ts - h943 drive w/ the 0800. when i load onto my usb and type in fsam 1234567 12345 and hit enter then i hit any key to continue then my mtk vender fails and hit Y to resend command and i turn the drive off and back on but it stays on the 0x51 and never goes off of it.

when you get there tryi hitting esc. . . it should move ahead, you may have to repeat that a few times

i have done that but it says unknown flash chip and stops.

ight, can you tell me all the steps you're taking from the very beginning?

i do everything that cofree says to do w/ jungleflasher and i put the firmware into the backups folder on the bootable usb that i made in iprep then i shutdown my computer and load onto the usb i turn my drive on and hook up the sata and then i type fsam 1234567 12345 i hit enter then i hit any key to continue then it says mtk vender failed to load on port 0x9880 and it says to hit Y to resend command and after that to power cycle the drive and i do all of that and it sticks on the 0x51 and if i hit esc then it says to the press R for read W for write, etc. and i have done both of those and it just says unknown flashchip and aborts.

I didn't think you got 0x51/D1 with the Samsung. I thought that was for the Benq...

If you know you port works, it might be worth trying to flash it in with DOSFlash32...