Robin Hoods Playground

This is crazy annoying. Especially since I have read just about everywhere people using jungle flasher successfully. I have a stock hitachi 78, latest jungle flasher, installed driver, framework 3.5, win xp 32 bit, etc.

Needless to say I have everything configured (or at least think I do) for it to run successfully. Before I installed the device driver (manually) so the pc can detect the drive I was able to get into jungle flasher no problem. After I installed the driver when i go to open jungle flasher my monitor goes black and the small green light turns yellow. otherwise indicating that there is no signal to the monitor.

i went as far as right clicking jungle flasher and running program in 640 x 480 screen resolution. Well that worked, but now the program is so large i cannot see the entire program and can only see a small part of it.

Advice???

Some machines are that way with JF, either you fiddle with it for hours/days or just look for another used/old computer to do your flashing.

Shootsteel wrote:Some machines are that way with JF, either you fiddle with it for hours/days or just look for another used/old computer to do your flashing.

not what i wanted to hear. thanks for the response

Have you tried Firmware Toolbox (4.8)??

I have problems dumping/flashing with JF, so i've stuck to FWT for hitachis...