Page 1 of 1
Hitachi 79 question
Posted: Mon Mar 30, 2009 9:07 pm
by xx0warrig0xx
My friend has a 79 and i DO NOT want to solder and might want to use this method please check if this is fine I have a ck3 Pro but i Just want to know please check and whatabout restoring this drive to OFW for upgrade?
[YouTube]
http://www.youtube.com/watch?v=5m_WeV0LoF8[/YouTube]
Re: Hitachi 79 question
Posted: Mon Mar 30, 2009 9:10 pm
by iamwatt
you don't have to solder. download and make a 79unlock disc and you'll be good to go with jungleflasher
Re: Hitachi 79 question
Posted: Mon Mar 30, 2009 9:17 pm
by xx0warrig0xx
iamwatt wrote:you don't have to solder. download and make a 79unlock disc and you'll be good to go with jungleflasher
Wait, i just realized that the only way the drive will be detected is if i use the Via drivers and not the port IO so what should i do? Should I play the disk then enable port IO then remove Via drivers? im in a pickle plz help
Re: Hitachi 79 question
Posted: Mon Mar 30, 2009 9:26 pm
by iamwatt
first of all what are you using to flash it, why would you have to enable and remove things. i've only used jungleflasher 1.51, i installed the IO drivers and used a onboard sata port. after you get the drive into mode b you then do the 79unlock
Re: Hitachi 79 question
Posted: Tue Mar 31, 2009 9:56 pm
by xx0warrig0xx
thats what I ment Im using my via card not my on board sAta. My drive wont be detected for the 79 unlock which means i have disable port IO enable via drivers etc then switch quickly please help?
Re: Hitachi 79 question
Posted: Tue Mar 31, 2009 10:16 pm
by iamwatt
try this
sadalius wrote:
Make sure you have portio32 installed. Open device manager and disable your VIA card.
Browse to X:\windows\system32\drivers and find a file called viamraid.sys, it could be a dll I can't remember for sure. Either way there is only one file named viamraid rename it to viamraid.bak or something.
Re-enable the VIA card in the device manager. It should show a yellow exclamation mark on it. Reboot your computer. Check device manager again to make sure it still has the yellow exclamation mark on it.
Try jungleflasher on all types of drives.
Remember to report back whether this works for you or not. Don't try this if you have no way of recovering drives if your PC locks up just in case or if your primary hard drive runs off your card or you have on board VIA sata controller because your computer won't be able to boot if you remove the driver and your primary hard drive is running of that controller.
Re: Hitachi 79 question
Posted: Wed Apr 01, 2009 6:23 pm
by xx0warrig0xx
No thats what i did lemme rephrase this question.
If my Via is disabled using the method above, how would I get it to play the unlok song if it is not going to be detected?
Re: Hitachi 79 question
Posted: Wed Apr 01, 2009 6:29 pm
by iamwatt
from my understanding it will detect it, the via card just wont show up in jungleflasher in that drop down menu on the right side.