Help needed with IPrep (No Valid Key Found)
Posted: Tue Mar 31, 2009 2:33 am
So I've done the prepping and everything, went to dump the drive, and it read the banks fine. Then after it did that, it pops up with *** No valid key found in BACKUPS\1234567\12345\BenQ-OFW.bin ***
It also says at the bottom "Please check the key range of Backups\1234567\12345\BenQ-OFW.BIN" and "Key block not copied - ABORTING!!!"
So I took the flash drive and put the backups folder on the laptop, and after which I tried again. Same thing.
So I checked my firmware with Firmware toolbox, and for the key it gave me "01010101FFFFFFFFFFFFFFFFFFFFFFFF" as the key. In midst of a panic, I download Keychecker and do the same thing but this time it gives me more of a hex key, kinda like "7-0F-D2-s blah blah blah". So my question is, where do I go from here and is this key I found in Keychecker my valid key?
Oh and this is a new replacement drive after my old BenQ drive went bad. Right now, I have the new drive hooked up and that is where this key came from. Am I supposed to back up the old drive or something first?
Thanks!
It also says at the bottom "Please check the key range of Backups\1234567\12345\BenQ-OFW.BIN" and "Key block not copied - ABORTING!!!"
So I took the flash drive and put the backups folder on the laptop, and after which I tried again. Same thing.
So I checked my firmware with Firmware toolbox, and for the key it gave me "01010101FFFFFFFFFFFFFFFFFFFFFFFF" as the key. In midst of a panic, I download Keychecker and do the same thing but this time it gives me more of a hex key, kinda like "7-0F-D2-s blah blah blah". So my question is, where do I go from here and is this key I found in Keychecker my valid key?
Oh and this is a new replacement drive after my old BenQ drive went bad. Right now, I have the new drive hooked up and that is where this key came from. Am I supposed to back up the old drive or something first?
Thanks!
