Page 1 of 1
lite on flash probelm
Posted: Fri Apr 03, 2009 3:01 pm
by Hexadecimal_7
Hey, I have successfully flashed a lite-on using the ck3 pro kit in the past, but this time when I am trying to get the key using JungleFlasher. I have the drive half open and am using the probe while the green light is illuminated. Last time I was using the older version of JF and now I am using version 1.55. I figured that getting the key was under the DVDKey 32 tam and clicking Get Key, Create Dummy.bin, Open as Source but I get an error saying ***WARNING*** Serial Data is bad. What could I be doing wrong this time around? Thanks guys.
Re: lite on flash probelm
Posted: Fri Apr 03, 2009 4:05 pm
by CoFree
if this drive flashed
then you would dump with the
"dummy from ixtreme" button under the dvd key 32 tad
Re: lite on flash probelm
Posted: Fri Apr 03, 2009 4:44 pm
by Hexadecimal_7
The drive has not been flashed before.
Re: lite on flash probelm
Posted: Fri Apr 03, 2009 4:50 pm
by CoFree
i have read about some people having a hard time with the new v1.55 jungle
make sure you reload the portio that comes with the new v1.55
if that dont work
you mat want to give iprep v8.8 a try.
Re: lite on flash probelm
Posted: Sat Apr 04, 2009 9:55 am
by Hexadecimal_7
OK... So I have narrowed the problem down to actually getting the DVD Key off the drive using the Probe. I seem to be having this problem no matter whether I run JungleFlasher or DOS Flash. I keep getting that same error message as I had said before. I had even used a small knife and shaved away some of the green on the motherboard to get at the circuit to try for a better probe, but still nothing. Has this problem happened to anyone lately, or is it just me that is doing something wrong. I am following all of the steps correctly and have flashed lite-on's in the past, but now it seems to be having this issue. Any help will be appreciated. Thanks a lot guys.
Re: lite on flash probelm
Posted: Sat Apr 04, 2009 12:41 pm
by CoFree
have you tried it by soldering the 707 point
you could have a bad probe (i guess)
Re: lite on flash probelm
Posted: Sat Apr 04, 2009 1:56 pm
by Hexadecimal_7
Hmm, I don't believe that I have a bad probe because when I try and use DOS Flash the status of the drive will not go beyond 'Status 0x51' like it should. I have the drive pushed half way in, but having no luck... If I do solder the R707 port will it work do you think? Thanks.
Re: lite on flash probelm
Posted: Sat Apr 04, 2009 2:45 pm
by Hexadecimal_7
Well it turns out that I was using the wrong COM port, lol. Something as difficult as I thought it had been, turned out to be as easy as THAT!. Ugh what a noob I am... Flashed and online! Thanks guys.
Re: lite on flash probelm
Posted: Sun Apr 05, 2009 7:06 pm
by CoFree
good job man
