Robin Hoods Playground

whats up everyone...just wondering what program is easier for flashing a lite-on drive jungle flasher or iprep ive watched both tut. on here both very well explained by cofree (good job man keep em coming ) just wanted to hear dif. opinions from people who have done lite-on's since i will soon be flashing one...

I use Jflasher to retreive the key/inq/ident/dummy .bin(s) create my CFW then I switch to iprep/dosflash to flash as JF has a tendency to lock up the drives and you end up in iPrep/dosflash anyways.

i find jungle flasher the easiest.
im basically still a complete novice at flashing but have done 7 drives now using jungle flasher and watching the tutorials on this site.
i did have trouble at 1st with pc freezing and stuff but was pretty simple to sort it all out in the end and it runs sweet as a nut now.

strykr535 wrote:.just wondering what program is easier for flashing a lite-on drive jungle flasher or iprep ive watched both tut.

you will get different things from different people

if you are using a via chipset
then i would say iprep
if its not a via then give jungle flasher a go.

but "Shootsteel" likes to do things the hard way and does a little of both.

i would not do it his way until you have a understanding of both programs.

I tend to do it the opposite way. i use iprep first, then jungleflasher to check the key then iprep again to finish off the flash but i tend to err on the side of caution.